Monochrome Brass Inlay | Encaustic Cement Tile | Eco Friendly
Elegant, sophisticated, and authentic the Brass Inlay Cement Tile will elevate the design aesthetic, which delivers an original yet classy look.
Suitable for walls or floors.
200 x 200 x 16mm.
Price is per M2. Pallet delivery option (D) needed on all orders.
PLEASE NOTE TO ORDER A FREE SAMPLE JUST CONTACT US WITH YOUR ADDRESS AND CONTACT DETAILS.
Installation 1. The installation of cement tiles is a simple and quick process. The tiles need to be placed on a perfectly levelled and clean surface, therefore prepare the concrete slab before and let it dry completely before placing the cement tiles. Never lay them onto the fresh concrete. It is important that the surface where you place the tiles is completely dry, otherwise the moisture will evaporate through the tiles, leading to composition of saltpetre deposits in form of white stains. 2. Leaving a space between the end of the floor and the wall is recommended, just enough so that the skirting covers this small space. In that way we will avoid having breakage problems due to structural movements of the building. 3. When the layer is dry, spread the tile adhesive on the back of the tile and the floor using the rake comb with fine tooth spacing (double spread of adhesive, also called “buttering”), in order to improve adhesion and prevent creating any empty spaces that may result in unsticking of the slab in the future. 4. The tiles need to be placed manually, one by one, without using a hammer or any other tool. The precision is required, as the tiles cannot be polished down like other materials. 5. The separation between tiles should be minimal, 1 to 2 mm, respecting the alignment for a good finish of the drawing. 6. When the installation is finished and the adhesive is dry, clean the surface with plenty of water to remove the thin layer of pigmented powder that covers the tiles.
Treatment For all of the treatments of cement tiles at Naturally Of Earth we recommend Fila products: 1. During the installation phase before grouting, apply an impregnating sealant (Fila MP90 Eco Xtreme) to the tiles with a soft cloth or brush. Allow at least two hours between coats. This product should be generously applied. 2. After one hour rub over the surface with a soft fluff free cloth to obtain a uniform finish and remove any excess sealer. 3. The aim is to completely fill the substrate with sealer without over applying it. The sealer will dry after two hours, but will take a further three days to become fully resistant.
Grouting 1. Before grouting apply an impregnating sealant to the tiles, this is so that the grout residues do not get deeply adhered to the tiles’ layer of pigments and these can be removed easily. 2. For the grouting do not use dyed grout. The pigments could leave irreversible stains in the slab. 3. Use a spatula to fill the spaces between the tiles. Do not put grout above the level of the tiles. If there is any excess grout, remove it immediately using a damp cloth. 4. Do not use any acidic or corrosive products to remove the excess or clean the stains of the grout.